Siting the emitters
When your theatre booked the system, you will have been told how many emitters you will need. This varies with the size of the theatre and the number of seats, however options are usually;
Under 120 seats – a single emitter is placed in the projection room porthole, facing the screen.
Up to 300 seats – two emitters are placed in the front corners of the theatre, facing the audience, high enough to reach each viewer without obstruction. They can also be placed at the back of the theatre as shown in the drawing
Up to 500 seats – two emitters are placed 1/3 of the way down the theatre, nearer the stage, at high level. A third emitter is placed at high level in the centre of the screen
Over 500 seats – talk to us !
In all but the single emitter’s case., cables need to be run to the emitters from the projector. We can either supply these cables in advance of where easy routing is not possible the theatre can buy their own for ongoing use.
These are 9pin multicore cables with a D connector on each end, male at the projector and female at the emitter. Run these cables soas to be safe and free from risk of damage.
